3d Printing Time Lapse

GoPro Session flexible mounts are available for the Krieger and Mitsuko. Please email if you’re interested.

$10 + shipping per case.

Advertisements

6 Degree Camera Bracket for QuadRevo frames

I designed this ABS camera mounting bracket for QuadRevo multirotor frames. This will add 6 degrees of upward tilt to any or the normal camera mounting positions. The pins are designed for heat staking, but if you want to use traditional screws and nuts, you can trim off the heat stakes and drill holes instead.

If you’re not familiar with heat staking, grab a soldering iron and a hobby knife. Heat the soldering iron up against the hobby knife while pressing the knife against the heat stake. It’ll melt and form a “mushroom” head holding the camera board down. Remove the soldering iron while keeping the knife in place for a few seconds, then remove.

Please email if you’re interested!

How to Setup a 19" TV for your FPV Base Station

I purchased an Insignia 19″ LCD from my local Best Buy, today. It was on sale for $100. I’m not sure how it will behave with static/blue screen and am expecting to have some issues on the edge of my video TX capability. Thankfully, I have RTH set up on all of my devices. Setting the TV up for FPV was pretty simple, the longest step was making a tripod mounting bracket.

Required Material

Insignia 19″ TV NS-19E310A13

– 5.5mm diameter DC plug

– Wireless video receiver (I’m using V2 of this one from readymaderc)

– 12V battery, I’m using a 5000mah 3S lipo pack

– Tripod, I’m using the heavy duty Bower tripod available here Fry’s

Wiring Steps


– provide power from your 12V battery to the 5.5mm DC jack plug. Center pin is positive.

– velcro your receiver to the back of the TV, wire video out from the receiver to video in on the TV

– provide power to the wireless receiver, you can split power from the same battery if you like

Mounting to Tripod


– I designed mounting bracket that screws into the 3″x3″ VESA hole pattern on the back of the TV. The bracket is compatible with the four M4 screws that come with the TV’s base.

– Bower says this is a “Universial” tripod mount, but I believe the square tripod adapter geometry has not been standardized. If you plan on using this with a non-Bower tripod, please compare your tripod adapter geometry for compatibility

– Bower tripod geometry: 32mm square at base, 38mm square on top. 8mm height between top and base.

– If you’re interested in a bracket, please email me. I will start selling them for $10, shipped to the USA via USPS.

– Bracket is compatible with other televisions that also use the 3″x3″ VESA hole pattern.